Features
HolyBro H7 V2 Kakute Flight Controller w/ BlueTooth Barometer OSD 5V 9V BEC Blackbox 2-6S
The Holybro Kakute H7 v2 Flight Controller is full of features including integrated Bluetooth,
HD camera plug, dual plug-and-play 4in1 ESC ports, 9V VTX ON/OFF Pit Switch, barometer,
OSD, 6x UARTs, 128MB Flash for Logging, 5V and 9V BEC, and bigger
soldering pad with easy layout and much more.
The Kakute H7 v2 builds upon the best features of its F7 predecessor and further
improves on hardware components and layout. With the additional integrated Bluetooth
chip onboard, you can perform configuration and tuning wirelessly on your phone with
the SpeedyBee Android & IOS App. The Kakute H7 is DJI HD ready. It has an easy
plug-and-play port with an on-board 9V regulator designed to power your HD video
transmitter such as the DJI/Caddx FPV Air Unit & Caddx Vista while supporting analog system.
It features an onboard “VTX ON/OFF Pit Switch” that allows you to completely power
off the video transmitter using a switch on your RC transmitter. Great if you are
working on your drone, waiting for the GPS to get a fix, getting ready for a race
while preventing it from overheating or interfering with others flying. It has 6x
dedicated UART ports with built-in inversion for peripherals
(UART2 is used for Bluetooth telemetry),
a 128 MB Flash for logging, Dual plug-and-play 4in1 ESC connectors, allowing easy
plug-and-play support for x8 & Octocopter configuration and keeping it simple and clean.
The integrated BetaFlight OSD makes it easy to display important information on your
FPV display like battery voltage, flight time, warnings, RSSI, smart audio features and more.
It is also ready for autonomous flight with the on-board barometer. There are LED & buzzer
pad, I2C pad (SDA & SCL) for external GPS/Magnetometers.
Product Details
* MCU – STM32H743 32-bit processor running at 480 MHz
* IMU – BMI270
* Barometer – BMP280
* OSD – AT7456E
* Onboard Bluetooth chip – ESP32-C3
- SpeedyBee IOS & Android App Compatible
- Note: The Bluetooth onboard is set to automatically turn off when the
flight controller is unlocked (arm) and turn on automatically
when the flight controller is locked (disarm).
* VTX ON/OFF Pit Switch – Switch can be enable using USER1 in Betaflight Mode tab.
- Warning: Do not enable this pit switch if you are using DJI FPV Remote Controller
* 6x UARTs (1,2,3,4,6,7; UART2 is used for Bluetooth telemetry)
* 9x PWM Outputs (8 Motor Output, 1 LED)
* 2x JST-SH1.0_8pin port (4in1 ESCs, x8/Octocopter compatible)
* 1x JST-GH1.25_6pin port (For HD System like Caddx Vista & Air Unit)
* Battery input voltage: 7V to 42V
* BEC 5V 2A Cont.
* BEC 9V 1.5A Cont.
* Mounting – 30.5 x 30.5mm/F4mm hole with F3mm Grommets
* Dimension – 35x35mm
* Weight – 8g
Item Packing
Kakute H7 V2 Flight Controller x 1
HL-H7-V2
Auto Pilot Controller
BRUSHLESS GIMBALS
Specials ...
