BGC Encoder Motor DM50-15 with slip ring & 1 BGC controller kit

3 x BGC AS5600 Encoder Motor DM50-15 with slip ring & 1 Basecam Electronics BGC controller built in to the YAW motor DM50-15, 3kg payload
ii12c encoder connection & BGC connection between the three motors 3 axes and the connection with the IMU uses ii2c bus connection, mother board and BGC driver board module, IMU model. Connection Block uses JST standard standard 5 pin connector connection, easy to connect slip ring, wiring simple, easy assembly and maintain. The center of each board has a 12-bit encoder, the motor is ready for encoder firmware. Board voltage 2s-4s lithium battery.
3 kg payload
Motor Dimensions 88x29.9mm
Weight 170g
Stator Dimension 49x33.5mm
Configuration 24N28P
copper Wire .30mm
Winding Type WYE
Max Normal Voltage 10.5-21V
Resistance 13.20
max current 2.5A
hollow diameter 12.6
max weight 0.8kg
Max Stall current 3
Diameter of Hollow shaft 8.1mm
https://www.basecamelectronics.com/encoders/#trial BGC Encoder Motor DOC DM 50-10 motor
BGC Encoder Motor DOC DM 50-15 motor
BGC Encoder Motor DOC DM 50-5 motor
DM BGC Encoder MOTOR Documentation