Alexmos SimpleBGC BGC 32BIT Extended 2-IMU Set

SimpleBGC 32bit Extended 2-IMU Set
SHIPPING BY DHL/FEDEX
YES, this is a GENUINE Alex Mos new 32 bit 3 axis controller!
SimpleBGC 32bit extended main bord – 1 pc
Motor 30 cm wires – 3 pcs
Battery 20 cm wire – 1 pc
Ferrite coils 10-15 mm diameter, 3-5 mm thickness – 3 pcs
Encoder 10 cm wires – 3 pcs
IMU sensor board – 1 pc
IMU 50 cm wire – 1 pc
Encoder-enabled firmware
CAN_Driver Kit includes three driver boards.
* Second I2C IMU is integrated in the board.
Basic functions of the controller
-32-bit MCU — ARM Cortex M4. Effectively calculates the complex tasks for 3-axis stabilization.
-Allows camera control with the RC or analog joystick.
-Use several switchable profiles for different modes of operation
-Supports variety of RC protocols: PWM, Sum-PPM, spektrum and s-bus.
- Battery voltage monitoring, compensating voltage drop in the PID-regulator.
- Low battery alarm (output to 5V active buzzer).
- Increased number of inputs for controlling signals + 3 additional reserved input/output AUX1-AUX3.
- Can supply up to 1A current for external devices on the 5V power line.
- Dedicated UART-socket to connect optional Bluetooth module
- Reverse-polarity protection, overheat and overcurrent protection
- USB interface for the PC connection, to configure, control and upgrade firmware.
-Graphical user interface to manage the settings. Windows / OS X / Linux versions.
- Control through the Serial-protocol using dedicated API.
- Improved attitude estimation algorythms
-Optional second IMU, that will increase the short-term precision of the stabilization 10x-30x times and will make stable work in any frame position.
General info on the Basecam site:
http://www.basecamelectronics.com/simplebgc32bit/
New firmware & GUI 2.4b8 for 32bitters is ready to go:
http://www.basecamelectronics.com/downloads/32bit/
New Basecam Configuration Guide:
http://www.basecamelectronics.com/co...how/?newsid=69
SimpleBGC 32-bit Extended controller is the advanced version of SimpleBGC 32-bit brushless gimbal controller introduces new capabilities:
Built-in Frame IMU
Current sensor to mesure battery power consumption
CAN-bus to replace I2C for the IMU sensor and other periphery connection
Dedicated 3x SPI/PWM ports for encoder connection
Additional I2C port to connect 2nd IMU or encoders
Built-in sound beeper
Up to 6s LiPo battery is supported
Specifications
Size of the board 50×50 mm
Distance between the mounting holes 45 mm
Diameter of the mounting holes 3 mm
Power supply voltage 8-26 V (3s-6s LiPo)
Maximum motor current 1,5 A
5V output current to power external devices up to 1 A
3V output current 150 mA
Wire Diamter