Cable cam wirecam BGC gimbal cable rig up to 10kg payload 5 unit

Cable Cam system that flies a camera over a rope tied between two points. Although the affordability and use of drones are increasing for aerial imaging, there are still many instances in which a Drone would either not work, would be illegal, unsafe, or would be just a noisy nuisance. Uses 1:7 Gear Ratio Provides high toque through 1:7 gear ratio. For the main driving part wheel, we used urethane material support 1kg to 10kg
35MM BALL-HEAD
WE HAVE ATTACHED A BALL-HEAD TO ALLOW ANGLE ADJUSTMENTS TO RETAIN GOOD
ANGLES FOR SHOOTING
Quality Aluminum Alloy, Steel, Rubber
Weight 3.3kg (7.26 lb)
Maximum Speed 40km
Body Length 668 x 210 x 118mm Wire Setting Distance Maximum 100m
Weight of Installation 20kg (44lb) (including the Wire Cam) Recommended: 9kg (19.8lb) Inclination angle Below 20 degrees
Li-Po Battery
Voltage 7.4 V 5200mAh (Basic Supply)
Consecutive Time 20~40 minutes (fully charged) Charging Time 70~80 minutes
HiTEC - FLASH7 or similar TXRX like AT9
Frequency Range 2.4 GHz
Weight 648g
Length 180 x 200 x 65 mm
Steel Wire
Quality Steel
Diameter 6mm
Length 50m
Weight 4.5kg
Hard Case
Outside Side 837 x 430 x 219 mm
Inside Size 820 x 410 x 210 mm
Buoyancy 67.2 kg (147.84 lb)
Weight 7.8 kg (17.16 lb)