-FS-CT6B
2.4G 6CH radio control System ( TX + RX )
-channels: 6channels;
-model
type: heli, airplane, glider;
-RF power: less than
20db;
-modulation: GFSK;
-code type: PPM/PCM;
-sensitivity:1024;
-low voltage warning: yes;
-DSC port: yes;
-charger
port: yes;
-power:12VDC(1.5AAA*8);
-weight:680g;
-ANT
length:26mm;
-size:190*80*240mm;
-Color: black;
-certificate:
CE FCC;
Features
-Inertial-based(6DOF IMU) self-stabilization
system. Good for AV/AP applications, but not suitable for acrobatics flights.
-4 channels Tx is enough. No more switches for the flight modes
-ARTF, no extra settings needed. Put on the props, the battery and the RX, then
turn on the Tx to take off !
-AP/AV based
-Auto Barometer-based altitude hold if no throttle input changed in 2s..
-X and Corss flight modes available. Only Cross mode was available in the
beginning. But new improvements for the X mode had been tested successfully.
-Optional single axis camera mount (pitch) with double axis self-stabilization (pitch
and roll).
-Larger MTM distance(580mm),larger payload (<580g),and longer flight time(25
mins with 3S Battery). Special props offered by the manufacture.
Powerful
-Buzzer warning for low battery, and optional lights for night flight (The
interfaces are available, but soldering should be done before coming out -of
the factory according to the demands of the costomers. In order to avoid some
trouble of making the hardware easy to be damaged).
-Other features considering to be supported in the future: Configuration
Software available and Firmware upgradeable.
-This is the RTF ,Including the remote control, receiver
and batteries
Item Packing
-Pre-installed aircraft main body, including
brushless ESC, flight control panel, motor X 1
-pre-installed stands unit, including 4 fixed nuts X1
-pairs of special propellers in positive and negative X 3
- bullet blade folders X 4
-Velcro X 1
-FS-CT6B 2.4G 6CH Transmitter&Receiver x 1
-Kypom 11.1v 2200mah 30c Battery x 1
-Battery Lipo Charger X1
Auto Pilot Controller
BRUSHLESS GIMBALS
Specials ...
